HP D7171A - NetServer - LPr Installation Manual page 17

Chapter 2
1. Set the new PSM in the open bay (see Figure 2-4). The power supply
can go into either side of the cage.
Figure 2-4. Setting the New Power Supply in the Open Bay
2. Push in the PSM, seat it firmly, and tighten the thumbscrews.
3. The new PSM fills only half the cage. Cover the other half with the
filler panel from the Upgrade Kit. Fasten the panel in place with its
thumbscrews.
The PSM is now installed. However, do not turn on the server until you install
the fan module from the Upgrade Kit. See Chapter 3.
Cage and Power Supply Installation
Set the new power supply
module in either side of the
open bay.
13