HP D7171A - NetServer - LPr Installation Manual page 12

Chapter 1
Remove two screws
securing LH 3r to rack
Figure 1-3. Screw and Cover Locations (LH 3r)
3. Slide out the NetServer until the rail locks "click" into place.
4. Loosen the thumbscrew at the front of covers 1 and 3 and pull the covers
forward, using the handles on the covers, and then lift them off the chassis
(see Figure 1-4).
Figure 1-4. Removing the Covers (NetServer LH 3r)
8
Cover 1
Cover 3
Do not remove three
screws securing
the hinge to the LH 3r
Cover 1
Introduction
Remove two screws
securing LH 3r to rack
Do not remove two
screws securing
the bracket to the LH 3r
Cover 3