Removing the Memory Board
To remove the memory board, follow this procedure:
1. Power down the HP NetServer. See Chapter 2 of the HP
NetServer LXr 8000 Installation Guide for details.
2. Remove the HP NetServer's front bezel. See Chapter 3 of the HP
NetServer LXr 8000 Installation Guide for details.
3. On the front of the HP NetServer, locate the LCD display. On top
of the display's housing is a small handle. With one finger, pull up
on this handle. The LCD display should move up about ½ inch
and stop. See Figure 2-8.
NOTE
18
If you do not push the LCD display up and out of the
way, you cannot remove the panel that covers the
memory bays.