Mount The Drive In The Netserver L Series; Step 1: Mount The Drive In The System - HP D7171A - NetServer - LPr Installation Manual

2 Mount the Drive in the NetServer
L Series
This chapter describes the installation of a drive in the NetServer L Series.

Step 1: Mount the Drive in the System

Determine what type of mounting tray or bracket is correct for the system.
Use the tray with the drive activity light for mounting a drive in the front of a
NetServer. The drives are shipped already mounted on this tray. To purchase the
tray separately, order Product Number D2198B (multipack).
Front view
Consult Information Assistant on the HP NetServer Navigator CD-ROM for your
system for additional information regarding the tray or bracket.
Attach a tray to a drive or change a factory-supplied tray (if needed) as follows:
Place the drive on a flat surface, free of static electricity, with the circuit
board of the drive facing up.
If your drive is on a tray that is not appropriate for your server, remove the
four screws attaching the drive to the tray and remove the tray. These
screws can be used to mount the drive on the tray or bracket.
Place the new tray or bracket on the drive.
Figure 2-1. Tray
15