Mount The Drive In Shelf 3 Or 4; Step 3: Connect The Drive - HP D7171A - NetServer - LPr Installation Manual

Chapter 3

Mount the Drive in Shelf 3 or 4

Remove the drive mounting tray from the system. (See Figure 3-2.)
Figure 3-2. Hard Disk Drive Mounting Tray
Align the four screw holes in the bottom of the NetServer E 45 tray with
the four screw holes in the bottom of the drive.
Loosely install all of the screws, then tighten the screws to no more than
eight inch-pounds (0.9 newton-meter).
Place the tray in the shelf opening and slide the tray into the shelf.
Align the screw holes at the front of the tray with the holes in the front of
the chassis.
Loosely install all screws, then tighten each screw to no more than eight
inch-pounds (0.9 newton-meter).

Step 3: Connect the Drive

Connect the SCSI data cable and power cable and complete the drive installation.
The SCSI cable is connected to the SCSI connector on the SCSI host bus adapter
board.
The correct cable for HP Ultra SCSI-3 drives has an active termination module on
one end of the cable. The active termination module is easy to recognize, because
it looks different from the other connectors on the cable. The cable bundled with
your system is actively terminated.
26
Mount the Drive in the NetServer E 45