Cr_Pointer Command; Cr_P-Mane Command; Cr_P-Manetime Command; Cr_On-Sta Command - Sanyo PLC-XU355A - 3500 Manual

PLC-XU305/355 Expand Serial Command Functional Specifications

9.11.10 CR_POINTER Command

Command "CR_POINTER" [CR]
Details Get Pointer setting status
Acceptable
%a
Response
Unacceptable
9.11.11

CR_P-MANE Command

Command "CR_P-MANE"[CR]
Details Get Power management setting status
Acceptable
Response %a
Unacceptable

9.11.12 CR_P-MANETIME Command

Command "CR_P-MANETIME"[CR]
Details Get time to start Power Management
Acceptable
Response %a
Unacceptable

9.11.13 CR_ON-STA Command

Command "CR_ON-STA"[CR]
Details Get Power ON Start setting status
Acceptable
Response %a
Unacceptable

9.11.14 CR_STANDBYMODE Command

Command "CR_STANDBYMODE" [CR]
Details Get Standby Mode setting status
Acceptable
Response %a
Unacceptable
"000_%a"[CR]
"SPOTLIGHTMAX" ------- Spotlight Maximum mode
"SPOTLIGHTMID" ------- Spotlight Medium mode
"SPOTLIGHTMIN" ------- Spotlight Minimum mode
"ARROW" ------------------- Arrow Mode
"FINGER" ------------------- Finger Mark Mode
"LASER" -------------------- Laser Mark Mode
"Error Code" [CR]
"000_%a"[CR]
"OFF" -------------------------- Power Management is OFF
"READY" ---------------------- Power Management is Ready
"SHUTDOWN" ---- Power Management is set to Shut Down mode
"Error Code" [CR]
"000_%a"[CR]
"001"~"030" -----------------------1 minute to 30 minutes
"Error Code" [CR]
"000_%a"[CR]
"ON" -------------------------- Power ON Start is ON
"OFF" ------------------------ Power ON Start is OFF
"Error Code" [CR]
"000_%a"[CR]
"ECO" -------------- Eco Mode
"NORMAL" -------- Normal Mode
"?"[CR]
61/68