Troubleshooting Guide - Honeywell Orbit MS7120 Installation And User Manual

T
ROUBLESHOOTING
The following guide is for reference purposes only. Contact a customer service
representative to preserve the limited warranty terms on page 33.
Symptoms
All Interfaces
During power
up the unit
beeps three
times.
During power
up the unit
razzes once
and the blue
LED flashes.
During power
up the unit
razzes twice
and both LEDs
flash in unison.
The unit has no
LEDs, beeper
or motor spin.
The unit has no
LEDs and / or
beeper.
The unit powers
up but does not
beep.
18
G
UIDE
Possible Cause(s)
There is a non-volatile
RAM failure.
There is a VLD failure.
There is a scanner
motor failure.
No power is being
supplied to the
scanner.
No power is being
supplied to the
scanner from host.
The beeper is disabled.
No tone is selected.
Solution
Contact a customer service
representative.
Contact a customer service
representative.
Contact a customer service
representative.
Check the transformer, outlet
and power strip. Make sure the
cable is plugged into the
scanner.
Some host systems cannot
supply enough current to power
the Orbit. Use the power supply
included with the scanner.
Enable the beeper.
Select a tone.