Password Screen - ZyXEL Communications WAP3205 User Manual

Chapter 12 Maintenance
The following table describes the labels in this screen.
Table 45 Maintenance > General
LABEL
Administrator
Inactivity Timer
Apply
Reset

12.4 Password Screen

It is strongly recommended that you change your WAP3205 v2's password.
If you forget your WAP3205 v2's password (or IP address), you will need to reset the device. See
Section 12.8 on page 111
Click Maintenance > Password.
Figure 73 Maintenance > Password
The following table describes the labels in this screen.
Table 46 Maintenance > Password
LABEL
Password Setup
Old Password
New Password
Retype to Confirm
Apply
Reset
106
DESCRIPTION
Type how many minutes a management session can be left idle before the session times
out. The default is 5 minutes. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle (not
recommended).
Click Apply to save your changes back to the WAP3205 v2.
Click Reset to begin configuring this screen afresh.
for details
DESCRIPTION
Change your WAP3205 v2's password (recommended) using the fields as shown.
Type the default password or the existing password you use to access the system in
this field.
Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays an asterisk (*) for each character you type.
Type the new password again in this field.
Click Apply to save your changes back to the WAP3205 v2.
Click Reset to begin configuring this screen afresh.
WAP3205 v2 User's Guide