Wps Station Screen; Scheduling Screen - ZyXEL Communications WAP3205 User Manual

10.10 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in
the wireless station utility within 2 minutes. To add the second wireless station, you
have to press these buttons on both device and the wireless station again after the
first 2 minutes.
Figure 65 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 40 Network > Wireless LAN > WPS Station
LABEL
Push Button
Or input station's
PIN number

10.11 Scheduling Screen

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN scheduling is
disabled by default. The wireless LAN can be scheduled to turn on or off on certain days and at
certain times. To open this screen, click Network > Wireless LAN > Scheduling tab.
WAP3205 v2 User's Guide
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations's wireless settings. See
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Use this button when you use the PIN Configuration method to configure wireless station's
wireless settings. See Section 8.3.2 on page
Type the same PIN number generated in the wireless station's utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
Chapter 10 Wireless LAN
Section 8.3.1 on page 60.
61.
97