Step 1-Preparing For Component Installation; Removing Components - HP Z600 - Workstation - 6 GB RAM Installation Manual

Step 1—Preparing for component installation
NOTE: Workstation models vary. All illustrations are examples only.
Download and install updates
1. Check for available system BIOS updates specified for your HP workstation model and operating
system at http://www.hp.com/go/workstationsupport.
2. Install the system BIOS updates, if available.
Accessing the internal components of the workstation
1. If you need help preparing the workstation for this installation, consult the removal and replacement
procedures in the service guide for your workstation at
workstation_manuals.
NOTE:
Guide on the Documentation and Diagnostics CD that shipped with your workstation.
2. Power down the workstation, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the workstation.
4. Remove the side access panel.

Removing components

1. If present, remove the card support to enable access to the expansion slots and system board
connectors.
2. On HP xw4600,
1394 port on the front of the workstation.
a. Remove the front bezel.
b. Remove the plastic cover or adhesive label over the port on the front of the workstation.
ENWW
For the HP Workstation series, these procedures are also available in the User
400, and 600 Workstations, there is a plastic plug or adhesive label over the
http://www.hp.com/support/
Step 1—Preparing for component installation 3