Step 3-Configuring The Cabling - HP Z600 - Workstation - 6 GB RAM Installation Manual

Step 3—Configuring the cabling
NOTE: To locate the appropriate connectors on the system board, see the service label on the
workstation access panel.
Table 1 Power and data configuration information
1394B ●
●
HP 400 and xw4600 Workstations power and data cabling
1. Connect a mini-plug power connector from the workstation power supply to the power connector
on the IEEE-1394 card
2. Connect the front IEEE-1394 I/O cable to the I/O connector on the IEEE-1394 card
Figure 3 Connecting the IEEE 1394 cables
ENWW
HP 400 Workstations
HP xw4600 Workstations
Power direct from power supply
Front IEEE 1394 I/O connects to
card
.
HP 600 Workstations
● Requires Y-adapter cable
● Front IEEE 1394 I/O
connects to card
HP 800 Workstations
HP xw9400 Workstations
● Requires Y-adapter cable
● Front IEEE 1394 I/O remains
connected to system board. Do
not disconnect.
Step 3—Configuring the cabling
.
2
5