HP Z220 Installation Manual page 14

3.
Install four M3 x 5mm screws (black) in the lower four mounting holes. See
guide screws on page
chassis near the optical bay.
4. Lift the green release lever for the optical bay and slide the DX115 unit into the bay until it is
stopped by the release latch. The following figures show examples of release levers and their
locations.
Figure 15
configuration
Figure 16
10 CRU Dataport DX115 kit installation
7. Spare M3 screws are supplied with your workstation and mounted on its
Installing the DX115 case in an HP Z210 CMT and HP Z400 workstation mini-tower
Installing the DX115 case in an HP Z210 CMT desktop configuration
Figure 9 Installing the
ENWW