HP Z220 Installation Manual page 12

7.
Rotate the drive cage to its upright position.
Figure 11
8. If the cables are not already routed and attached to the system board:
a.
Connect the SATA data cable to the system board connector labeled SATA1.
b. Route the data cable through the cable guides to keep the data cable from being pinched by
the drive cage when raising or lowering it. One guide is located on the bottom side of the
drive cage. The other is part of the chassis frame under the drive cage. Route the data cable
through these guides before connecting it to the optical drive.
Figure 12
8 CRU Dataport DX115 kit installation
Rotating the drive cage up
Routing the drive cable
ENWW