b.
Disconnect the power cable (1) and data cable (2) from the rear of the optical drive.
Figure 6
c.
Rotate the drive cage back down to its normal position.
CAUTION:
pinch the cables and damage them if they are not routed correctly.
d.
Press down on the green drive retainer button located on the left side of the drive to
disengage the drive from the drive cage. While pressing the drive retainer button, slide the
drive back until it stops, then lift it up and out of the drive cage.
Figure 7
6
CRU Dataport DX115 kit installation
Removing the cables
Check clearances on the cables when you rotate the drive cage. The cage may
Removing the optical drive
ENWW