HP Z200 - Small Form Factor Workstation Setup And Configuration Manual page 8

Default Setting
Recommended Setting
Note that spaces are not accepted in the host name. Make sure there is not
a duplicate host name on the network. Hostnames can be used in place of
the system's IP for any applications requiring the IP address.
b. Domain Name
Enter a domain name
Default Setting
Recommended Setting
The domain name is blank by default. If it is not populated, then the default
domain of "Provisionserver" will be used when connecting to a Setup and
Configuration Server.
If the name of the S&CS is not "Provisionserver" and the domain name is
blank, then an alias must be set up in the DHCP server to redirect the
connection for "Provisionserver" to the proper S&CS domain name.
If the domain name field is populated, then that will be the domain used.
However, if there is no response after four DNS queries to the named
domain, then that domain name will no longer be used and the default
"Provisionserver" will be used.
c. Share/Dedicated FQDN
Default Setting
Recommended Setting
This setting determines whether the Intel ME Fully Qualified Domain Name
(FQDN) (i.e. the "HostName. DomainName") is shared with the host and
identical to the operating system machine name or dedicated to the Intel ME.
d. Dynamic DNS Update
Default Setting
Recommended Setting
If Dynamic DNS Update is enabled then the firmware will actively try to
register its IP addresses and FQDN in DNS using the Dynamic DNS Update
protocol. If DDNS Update is disabled then the firmware will make no attempt
to update DNS using DHCP option 81 or Dynamic DNS update. If the DDNS
Update state (Enabled or Disabled) is not configured by the user at all then
the firmware will assume its old implementation where the firmware used
DHCP option 81 for DNS registration but did not directly update DNS using
the DDNS update protocol. For selecting "Enabled" for Dynamic DNS
Update it is required that the Host Name and Domain Name must be set.
When DDNS Update option is enabled, the MEBx menu will display
"Periodic Update Interval" and "TTL" options.
- Periodic Update Interval: Enter a desired interval between 20 minutes –
1440 minutes
- TTL: Enter desired time in seconds
: None
: User Dependent
: None
: Network Dependent
: Shared
: Shared
: Disabled
: Disabled
8