Bios Prerequisite; Manual Mode (Smb Mode) - Amt Setup And Configuration Steps - HP Z200 - Small Form Factor Workstation Setup And Configuration Manual

BIOS Prerequisite

This whitepaper is for the HP Z200 workstation. The HP Z200 workstation uses the
786H3 BIOS family.
The system BIOS and the ME FW must be updated individually. Refer to the BIOS
Flash Whitepaper at www.hp.com for more information on flashing the system
BIOS and ME FW.
Manual Mode (SMB Mode) – AMT Setup and Configuration
Steps:
When going through the options in the MEBx for the first time (Factory phase), the
default settings are in place. This whitepaper details HP recommended settings on
options, some of which may be the same as the default selection. Even though the
default setting is set and used for certain options, it is good practice to double
check important options.
1. Hit Ctrl-P during POST to enter Management Engine BIOS Extension (MEBx)
Setup.
a. This option is by default not shown during the HP splash screen.
b. It can be displayed during POST if set in F10-Setup.
Figure 1: Intel MEBx Password Screen
2. Enter the default password.
The default password is "admin". Passwords are case sensitive.
5