Enterprise Mode - Amt Setup And Configuration Steps - HP Z200 - Small Form Factor Workstation Setup And Configuration Manual

Enterprise Mode – AMT Setup and Configuration Steps:
The AMT Setup portion for Enterprise mode is the same as SMB mode. Repeat
Steps 1 through 15 to perform AMT Setup. This will take the system from Factory
mode to In Setup Mode.
Refer to Manual Mode – AMT Setup and Configuration for screen shots of MEBx
menus and full text. The following are quick steps for AMT Setup.
1) Get into the MEBx by pressing Ctrl-P during POST.
2) Enter the default password "admin".
3) Change the MEBx password, follow strong password guidelines.
4) Go into Intel ME Platform Configuration.
5) Check the Intel ME State Control, select Enabled.
6) Check the Intel ME Firmware Local Update Qualifier, select Always Open.
7) Go into Intel ME Power Control.
a. Go into ME ON in Host Sleep States, select Option 2 (Desktop: ON in S0,
ME Wake in S3, S4-5)
8) Go into the Intel ME General Settings.
The Intel ME Platform Configuration screen has more options than could be
displayed in one page. More options are available if the menu is scrolled
down.
9) Password Policy
Default Setting
Recommended Setting
This option will determine if the local MEBx password can be modified from a
remote console.
Option
Default Password
Only
During Setup and
Configuration
Anytime
: Default Password Only
: Default Password Only
Effect
This option will allow the MEBx password to be
remotely modified only if it is the default "admin"
password.
This option will allow the MEBx password to be
remotely modified only during Setup and
Configuration of the AMT platform.
This option will allow the MEBx password to be
remotely modified at any time.
26