HP Vectra VE 5/xxx - 2 Manual page 36

3 Troubleshooting and Repair
Using SETUP to Configure the PC
Setup Item
Memory and Cache
Memory caching
Memory hole
Shadow/Cache ISA Option
ROMs
Hard Disk Drives
Hard disk drive 0 (xxxx MB) 642 MB
Hard disk drive 1 (xxxx MB) xxxx MB
Hard disk drive 2 (xxxx MB) xxxx MB
Translation method
On-board Bus IDE adapters
Hard disk drive x (xxxx MB)
Autotype fixed disk
Type
Cylinders*
Heads*
Sectors/Track*
Multi-sector transfers*
LBA mode control*
32 bit I/O
Transfer mode*
*Only available if "User" mode has
been selected as "Type".
32
Default
Both Controls internal (L1) and external cache (L2) memory
caching.
Disabled Sets a 1MB memory hole between 15 and 16 MB if
needed. You need at least 16 MB for this option to be
available.
Enabled Enables shadowing and caching for ISA "Non-PnP" Option
ROMs for region X-Y, in order to improve performance.
Note that some Option ROMs cannot be shadowed.
Sub-menu items for each of these fields are given below.
It is not recommended to connect a CD-ROM on a
channel which already has an IDE hard disk drive.
Extended Select "Standard" only if you are running a UNIX
Operating System.
Both Enable or disable the on-board IDE adapters.
"Primary" enables only the HDD data cable (marked
"HDD" next to the system board attachment).
"Both" enables the HDD data cable and the CD-ROM data
cable (marked "CD-ROM" next to the system board
attachment).
Automatically attempts to detect and identify the IDE
drive when you press the Enter key.
User 642 MB Select "Auto" for automatic hard disk drive detection. (To
initiate automatic hard disk detection, press the Enter key
at the "Autotype fixed disk" item). "User" allows you to
edit all the detected parameters. Select "CD" if drive is an
IDE CD-ROM, and "None" if there is no drive.
1120 Sets the number of hard disk drive cylinders.
14 Sets the number of hard disk drive heads.
40 Sets the number of hard disk drive sectors per track.
8 sectors Determines the number of sectors per block for multiple
sector transfers.
Enabled Enable or disable Logical Block Addressing mode in place
of Cylinder—Heads—Sectors.
Enabled Enable or disable 32 bit data transfer.
PI0 mode 3 Selects the hard disk drive transfer mode and data
transfer rate.
Action