Replacing Dimms - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 7
4. Lay the server on its side (components showing).
5. Select the desired DIMM and open the retaining latches completely.
This forces the DIMM up in the slot and makes it easier to remove.
6. Lift the DIMM completely away from the slot.
7. Place the DIMM in its anti-static container.
8. Repeat Steps 5-7 for as many DIMMs as you need to remove.
System Board

Replacing DIMMs

1. Choose a DIMM slot for the desired DIMM.
While the four system board slots can accept different size DIMM in any configuration, HP recommends
installing the smallest capacity DIMM in slot 4 and progressively larger capacity modules in slots 3, 2 and 1.
2. Spread the two retaining latches on the slot outward.
CAUTION
Use only HP DIMMs, which are 184-pin, 3.3V, PC2100 (266
MHz), buffered ECC DDR DIMMs. The EDO DIMMs and
PC 100 SDRAM DIMMs from earlier hp server models will
fit into the DIMM slots in the hp server tc2120, but the EDO
DIMMs and PC 100 SDRAM will not function properly. HP's
warranty does not apply to non-HP parts.
3. Remove a DIMM from its protective container, handling the module by its edges.
If necessary, lay it on an anti-static surface until you are ready to install it.
Figure 7-8. Removing DIMMs from System Board
4 3 2 1
DIMM Slots
Replacing Parts
90