Replacing The Flexible Disk Drive - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 7
c. Remove the two screws from the side of the FDD assembly.
Figure 7-2. Removing the Flexible Disk Drive (FDD)
d. Remove the flexible disk drive from the tray.
7. Place the flexible disk drive in an anti-static bag.

Replacing the Flexible Disk Drive

1. If not already mounted, insert the new drive in the tray (pin side first), and then replace the side screws.
2. With the cable connectors toward the rear of the chassis, slide the FDD assembly all the way into the
chassis, until the FDD assembly snaps into place.
The flexible disk drive is only mounted in the top shelf (shelf 1).
3. At the rear of the flexible disk drive, carefully connect the power and data cable.
4. Replace the upper bezel.
5. Replace the left side cover.
6. Replace the external cables and power cord.
7. Power on the server as described in
Removing the CD-ROM
1. If the server is operating, power down the server.
Refer to Chapter 1‚ Controls and Indicators
2. Disconnect the power cord and any external cables connected to the server.
If necessary, label each one to expedite re-assembly.
Chapter 1‚ Controls and Indicators.
for instructions.
Replacing Parts
82