Hardware Changes; General Hardware Installation Sequence - HP t5740e - Thin Client Hardware Reference Manual

2

Hardware Changes

General Hardware Installation Sequence

To ensure the proper installation thin client hardware components:
1. Back up any data, if necessary.
2. If the thin client is powered on:
a. Turn the unit and any other attached devices off.
b. Disconnect the power cord from the wall outlet.
c. Disconnect any external devices or cables, such as an antenna or cable lock.
WARNING!
sure to disconnect the power cord from the wall outlet and allow the internal system components
to cool before touching.
WARNING!
plug telecommunications or telephone connectors into the network interface controller (NIC)
receptacles.
CAUTION:
optional equipment. Before beginning these procedures, ensure that you are discharged of static
electricity by briefly touching a grounded metal object. See
for more information.
3. Remove the secure USB compartment cover. See
Compartment Cover on page 12
4. Remove the stand, if it is installed. See
5. Remove the side access panel and metal side cover. See
Access Panel and Metal Side Cover on page 14
6. Remove any hardware that you will replace.
7. Install or replace equipment. For removal and replacement procedures, see the following
sections:
●
Installing the USB Device on page 17
●
Installing the PCI Express Expansion Module and PCI Express Card on page 21
●
Removing and Replacing the Battery on page 17
●
Installing a Secondary Flash Memory Module on page 18
●
Installing a Second SO-DIMM on page 19
NOTE:
8. Replace the side access panel and metal side cover. See
Access Panel and Metal Side Cover on page 14
ENWW
To reduce the risk of personal injury from electrical shock and/or hot surfaces, be
To reduce the risk of electrical shock, fire, or damage to the equipment, do not
Static electricity can damage the electronic components of the thin client or
Option kits include more detailed installation instructions.
Removing and Replacing the Secure USB
for more information.
Removing the Stand on page 6
for more information.
for more information.
General Hardware Installation Sequence
Electrostatic Discharge on page 32
for more information.
Removing and Replacing the Side
Removing and Replacing the Side
11