Removing A 3.5-Inch Drive From A Drive Bay - HP t200 Zero Maintenance And Service Manual

5. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive
toward the front of the computer until it locks into place.
Figure 5-16
6. Rotate the drive cage to its upright position.
7. Connect the SATA data cable to the white SATA system board connector labeled SATA2.
8. Route the data cable through the cable guides.
CAUTION:
drive cage when raising or lowering it. One is located on the bottom side of the drive cage. The
other is located on the chassis frame under the drive cage. Ensure that the data cable is routed
through these guides before connecting it to the optical drive.
9. Connect the power cable and data cable to the rear of the optical drive.
NOTE:
system board to the hard drive, then to the rear of the optical drive.
10. Rotate the drive cage back down to its normal position.
CAUTION:
11. Replace the front bezel (if removed) and access panel.
12. If the computer was on a stand, replace the stand.
13. Reconnect the power cord and turn on the computer.
14. Lock any security devices that were disengaged when the access panel was removed.

Removing a 3.5-inch Drive from a Drive Bay

CAUTION:
computer.
Installing the Optical Drive
There are two cable guides that keep the data cable from being pinched by the
The power cable for the optical drive is a three-headed cable that is routed from the
Be careful not to pinch any cables or wires when rotating the drive cage down.
All removable media should be taken out of a drive before removing the drive from the
Drives 53