Epson SureLab D3000 - Single Roll Operation Manual page 113

Error ID
2401 Adjusting heater unit temperature. Please wait. Printing starts
automatically when temperature adjustment is complete.
Click [Start] to print without waiting for the process to
complete.
(Note) Uneven color may occur if printing is started before
processing is complete.
7102 The motor temperature exceeded the maximum value.
Leave the printer power on and wait for at least 30 minutes
while the printer cools down, and then click [OK].
2402 The heater unit is not installed.
Install the heater unit, and then click [OK].
2129 Select a paper roll which the paper will be loaded from.
Click [Rear] to print from the rear roll.
2130 Select a paper roll which the paper will be loaded from.
Click [Front] to print from the front roll, or click [Rear] to print
from the rear roll.
2131 A paper jam occurred.
Remove the paper inside the printer, rewind the paper onto the
roll, and then reload it to the paper feed slot.
Click [OK] after loading the paper.
2132 The front roll is out of paper.
Remove the paper from the tray.
Load new paper, and then click [OK].
2133 The rear roll is out of paper.
Remove the paper from the tray.
Load new paper, and then click [OK].
2134 A paper jam occurred in the back printing unit.
Remove paper inside the printer, and then reload the paper.
Click [OK] after loading the paper.
2135 A paper jam occurred in the decurl unit.
Remove paper inside the printer, and then reload the paper.
Click [OK] after loading the paper.
2136 A paper jam occurred in the long paper ejection unit.
Remove paper inside the printer, and then reload the paper.
Click [OK] after loading the paper.
2001 Ink cartridge cover open.
Close the cover, and then click [OK].
2002 Maintenance tank cover open.
Close the cover, and then click [OK].
Troubleshooting
Message
113
What to do
Please wait. Auto printing starts when
the heater reaches a suitable
temperature.
By clicking Start, you can print before
the warm up is complete, however
uneven color may occur.
Leave the printer power on and wait
for at least 30 minutes while the
printer cools down, and then click OK.
Install the heater unit, and close the
cover. If an error is displayed on the
Client PC, click OK.
Click Rear to print from the rear roll.
Click Front to print from the front roll,
or click Rear to print from the rear roll.
Remove paper from the printer,
reload the paper, and then click OK.
U "When the Paper Jams" on page
120
Load new paper, and then click OK.
U "Replacing Paper" on page 26
Load new paper, and then click OK.
U "Replacing Paper" on page 26
Remove paper from the printer,
reload the paper, and then click OK.
U "When the Paper Jams" on page
120
Close the ink cartridge cover. If an
error is displayed on the Client PC,
click OK.
Close the maintenance tank cover. If
an error is displayed on the Client PC,
click OK.