HP Rp3000 - Point of Sale System Troubleshooting Manual page 62

NOTE:
Illustrated Parts & Service Map (IPSM) for that particular system.
5. Remove the CMOS jumper from pins 1 and 2 and put the jumper on pins 2 and 3. This clears
CMOS.
6. Put the jumper back on pins 1 and 2.
7. Replace the computer cover or access panel.
8. Reconnect the external devices.
9. Plug in the computer and turn on power.
NOTE:
that configuration changes have occurred. Use Computer Setup to reset any special system setups
along with the date and time.
For instructions on Computer Setup, see the Computer Setup (F10) Utility Guide.
56 Appendix B Password Security and Resetting CMOS
For assistance locating the CMOS jumper and other system board components, see the
You will receive POST error messages after clearing CMOS and rebooting advising you
ENWW