Boot Procedures - HP Rp2430 - Server - 650 MHz User Manual

A-Class Server Installation
A-Class Server Power Up and Boot Procedures
Step 7. To add "btlan3" driver support to the kernel, edit the /stand/system file and add the line:
btlan3. To access the file, type the following command when the system prompt "#"
displays: vi /stand/system. When the file opens, add the "btlan3" line.
Step 8. Now, rebuild the kernel and reboot the system. Type the following command when the
system prompt "#" displays: mk_kernel -o /stand/vmunix Press
NOTE Disregard the /usr/ccs/bin/ld: (Warning) "Linker features were used..." This warning does
not apply to this procedure.
Then, type the following command when the system prompt "#" displays: reboot -r
Press
Step 9. Finally, type the following command when the system prompt "#" displays:
/sbin/set_parms initial Press

Boot Procedures

Boot to Initial System Loader (ISL) (Optional)
If you wish to verify that all external devices are identified by the server before booting
HP-UX:
Step 1. Interrupt the boot process if AUTOBOOT is enabled.
Step 2. At the firmware Main Menu screen, type, bo pri.
Step 3. At the, Interact with IPL? prompt, type, y.
The ISL> prompt will be displayed.
Run Online Diagnostic Environment (ODE) Mapper (Optional)
Step 1. At the, ISL> prompt, type, ODE.
Step 2. At the, ODE> prompt, type, run mapper.
Compare the ODE Mapper output to the devices present. Address any discrepancies
before continuing. To exit ODE, type exit at the, ODE> prompt. This will return you to
the, ISL> prompt.
Boot HP-UX
•
•
For configuration of HP-UX, refer to http://eproducts.hp.com/.
58
. The system should now boot with an error-free /etc/rc.log file.
Enter
If the boot process was interrupted to run ODE Mapper, that process is resumed by
typing, hpux at the, ISL> prompt.
If the boot process was not interrupted, HP-UX will automatically boot.
. Network configuration is now complete.
Enter
.
Enter
Chapter 2