Kyocera FS-C5350DN Advanced Operation Manual page 81

>>RAM Disk Size
>Hard Disk
Using the Operation Panel
RAM Disk Size (Setting the RAM disk size)
Use this procedure to set the amount of memory used for the RAM disk.
IMPORTANT The RAM Disk Size menu option only appears when
RAM Disk Mode
1
2
119 MByte
3
4
Hard Disk (Using the optional hard disk)
Installing the optional hard disk into the printer allows you to perform the
following operations on the hard disk.
• Format (Formatting hard disk)
When an optional hard disk is inserted into the printer for the first time, it
must be formatted before use.
This menu is displayed only when the optional hard disk is installed on the
printer.
1
2
>
is set to On .
Press while >RAM Disk Mode
Press [OK]. The message display shows a blinking cursor (_). Press
or to display the desired size. Definable RAM disk size is 001
to 512. Use and to move the cursor right and left.
This range varies depending on the total memory size of the printer.
When the desired RAM disk size is displayed, press [OK].
Press [MENU]. The display returns to Ready. Turn the printer off and
then on again. The selected RAM disk size is activated after the
printer is restarted.
Note If the optional hard disk is installed in the printer, the
Custom Box and Job Box will be available.
Press while Device Common > is displayed.
Press or repeatedly until >Hard Disk > appears.
On > is displayed.
2-57