Loading Paper; Connecting Cables; Selecting The Message Language - Kyocera FS-C5100DN Installation Manual

3

Loading Paper

1
Pull the paper cassette all the way out
of the printer.
5
Fan the paper, then tap it on a level
surface to avoid media jams or skewed
printing.
4

Connecting Cables

1
Turn the power switch off (O).
5

Selecting the Message Language

1
Turn the power switch on (|).
Important:
The printer will begin
cleaning the LSU; this will take
approximately 70 seconds.
Refer to the Operation Guide to install the printer driver and to set network parameters.
© 2008-2009 by KYOCERA MITA Corporation All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan
2
Turn the paper size dial so that the size
of the paper to use appears in the
paper size window.
Paper Size Dial Paper Size Window
6
Load paper in the cassette, with the
side to be printed upward.
2
Connect the printer to the PC or your
network device. Use shielded interface
cables. These cables are sold
separately.
USB Interface
Network Interface
Remove the cap, when using the
network interface.
2
Wait until the message display
indicates MSG Language. The default
message language is English.
3
Adjust the paper width guides to fit the
paper size.
Paper Width Guides
Important:
Do not exceed the upper limit
of the cassette. Otherwise, it may cause
paper jams.
Limit Mark
3
Connect the power cord to the printer
and the other end into a power outlet.
3
To change the language, press [ ] or
[ ] repeatedly until the message
display shows the desired language.
4
Adjust the paper length guide to fit the
paper size.
Paper Length Guide
7
Insert the paper cassette into the slot in
the printer. Push it straight in as far as
it will go.
4
Press [OK]. The message language
will be changed.
Printed in China 302HN56022 Rev.1.2 2009.7