Regulatory And Environmental Information - HP Designjet 3D User Manual

Hp designjet 3d removal system - user's guide: english
Hide thumbs Also See for Designjet 3D:
Table of Contents

Advertisement

Regulatory and Environmental Information

Regulatory Model Identification Number
For regulatory identification purposes, your product is assigned a Regulatory Model Number.
The Regulatory Model Number for your product is BCLAA-0904. This regulatory number should
not be confused with the marketing name (such as HP Designjet 3D Removal System) or product
numbers (such as Z####X, where Z and X are any single letter and # is any number).
EMC Class A Warning
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
FCC Statements (U.S.A.)
The U.S. Federal Communications Commission (in 47 cfr1 5.105) has specified that the following
notices be brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Shielded cables: Use of shielded data cables is required to comply with the Class A limits of
Part 15 of the FCC Rules.
Caution: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment
not expressly approved by the Hewlett-Packard Company may cause harmful interference and
void the FCC authorization to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will
be required to correct the interference at their own expense.
Canada Electromagnetic compatibility (EMC)
Normes de sécurité (Canada)
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe A prescrites dans le réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
DOC statement (Canada)
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Canada Safety Statement
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010- 1 , second
edition, including Amendment 1, or a later version of the same standard incorporating the same
level of testing requirements.
24 Chapter 9 Supplemental Information
WARNING

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 3d removal system

Table of Contents