Overview; How It Works - HP Designjet 3D User Manual

Hp designjet 3d removal system - user's guide: english
Hide thumbs Also See for Designjet 3D:
Table of Contents

Advertisement

2

Overview

The HP Designjet 3D Removal System is specifically developed to provide efficient removal of
support material from models built with HP Designjet 3D printers.

How it works

The system removes support material by immersing models in a bath of water with a specific
amount of cleaning agent bags added to the cleaning agent receptacle. The system heats and
circulates solution around the models in the cleaning tank. The solution dissolves the support
material without harming the underlying model material. Over time, depending on geometry
and the amount of support material, all the support material is dissolved and the models are
ready to be removed, dried and used for their intended purpose.
The system incorporates the following functions:
Automatic water fill
User selectable cleaning tank level (half or full)
Automatic water drain
Automatic timing device for user selectable short, medium, or long cycles
Automatic lock/unlock before and after cycling
Automatic rinse and drain cycle
Figure 1
Sequence of Operation
Power on the System
Place model(s) in model basket
Pour in all the contents of the
cleaning agent bag(s)
Select:
Cleaning tank level
Cycle length
Press start cycle button
Lid locks
2
Chapter 2 Overview
Wash cycle
Drain
Rinse cycle
Drain
Lid unlocks
Remove model(s)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 3d removal system

Table of Contents