HP Designjet 3D User Manual page 19

Hp designjet 3d removal system - user's guide: english
Hide thumbs Also See for Designjet 3D:
Table of Contents

Advertisement

Problem
Models not clean
The system is leaking
Yellow flashing process
error LED
Red flashing process error
LED with cycle length LEDs
shown:
Red flashing process error
LED with cycle length LEDs
shown:
Red flashing process error
LED with cycle length LEDs
other than shown above.
Recommendation
Make sure all the contents of the specified number of cleaning
agent bag(s) is used.
Make sure the correct cleaning tank level is selected.
Make sure the correct cycle length is selected.
Repeat the cleaning cycle.
Make sure the model basket is used to submerge models in the
cleaning solution and the correct lid position is selected.
Verify that the inlet and drain hose connections are tight.
Make sure the system lid is fully closed.
If recovering from a power loss, press the cancel button.
Verify that the water is fully turned on.
Power cycle the ON/Off switch at the back of the system to
reset. Call Customer Service if the problem persists.
Verify that the drain hose is not clogged.
Verify that there are no kinks in the drain hoses.
Make sure the system is at least 20 cm (8 in.) above the drain
hose discharge.
Make sure that no section of the drain hose is higher than the
system discharge.
Power cycle the ON/Off switch at the back of the system to
reset. Call Customer Service if the problem persists.
Power cycle the ON/Off switch at the back of the system to
reset. Call Customer Service if the problem persists.
Troubleshooting
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Designjet 3d removal system

Table of Contents