Connecting The Signal Cable - Eizo RADIFORCE RX211 User Manual

2. Cable Connection and Screen Adjustment

-. Connecting the signal cable

NOTE
•Be sure that the power switches of both the PC and the monitor are OFF.
•Refer to the PC user's manual when connecting the monitor.
1
Rotate the monitor ninety degrees counter-clockwise into the portrait
position.
2
Plug the signal cable into the connector at the rear of the monitor and
the other end of the cable into the video connector on the PC.
After connecting, secure the cable connectors with the attached screw-in fasteners.
Digital Input
Connect to SIGNAL1 (DVI-D Connector).
Signal Cable
Signal cable (FD-C39 enclosed) Video Output
Analog Input
Connect to SIGNAL2 (D-Sub 15 pin Connector).
Signal Cable
Signal cable (MD-C87 enclosed) Video Output Connector /
1
SIGNAL1
DVI-D
Connector on PC
Connector / DVI-D
Connector on PC
D-Sub mini 15 pin
SIGNAL2 D-Sub mini 15
Power cord
• Exclusive graphics board
(p. 42)
• Standard graphics card
• Power Macintosh G3
(Blue & White) / Power
Mac G4 (VGA)
PC
PC