Adding Or Removing Printers; Adding A Printer; Removing A Printer; Replacing A Printer - Epson C323011 - TM J2000 B/W Inkjet Printer Installation Manual

Adding or Removing Printers

To add a printer to the computer or remove a printer that is no longer necessary from the
computer, follow the procedures below.

Adding a printer

To add a printer, install the printer driver and configure the port by following "APD Installation
and Printer Driver Setup" on page 2-5 .
Note:
You cannot add the printer driver directly from the Printers and Faxes screen.
When connecting a USB printer, you cannot add the printer driver using the Windows plug and
play feature.

Removing a printer

To remove the driver of a printer that is no longer necessary from the computer, uninstall the
printer driver by following "Uninstalling a printer driver" on page 2-27 .

Replacing a printer

When replacing a printer for another of the same model and same interface due to repair, for
example, note the following points.
Make sure the DIP switches on the new printer are configured with the same settings as those on
the replaced printer, regardless of the interface.
Serial
Parallel
USB
Ethernet
Rev.B
If the DIP switch settings for serial communication are the same, no
configuration is necessary following the replacement.
No configuration is necessary following the replacement.
If the printer's interface card changes because the printer is changed, the
APD recognizes it as a new printer connection and therefore generates a
new Epson Port (USB). For this reason, you must configure the newly
generated Epson Port with the same settings as those of the Epson Port to
which the printer driver was assigned.
No configuration is necessary on the printer driver if the same IP address
as for the replaced printer is used for the new one.
Advanced Printer Driver Installation Manual
APD Installation and Setup 2-19