Epson C323011 - TM J2000 B/W Inkjet Printer Installation Manual page 27

The setting items are as follows.
Printer Setting
Set Default Printer
Name
Printer Port Setting
Transmission Retry(seconds) The time interval for retrying transmission after
Port Type
Selects the interface connecting the computer and printer, to which the configured
settings apply. The default is "LPT" (Parallel).
The available settings for each type of port are as follows.
• Parallel
• Serial
• USB
• TCP/IP
Rev.B
Select the parallel port to be used.
Port
BaudRate
DataBits
Parity
StopBits
FlowControl
There are no items to configure.
IP Address
Advanced Printer Driver Installation Manual
Check when configuring the printer as that normally
used from the Windows applications.
The printer driver name. This is changeable.
timeout.
The default is "10."
Select the COM port to be used.
The default is "COM1."
Sets the BaudRate. The default is "38400."
Sets the DataBits. The default is "8."
Sets the Parity. The default is "None."
Sets the StopBits. The default is "1."
Sets the data flow control type to be used between the
computer and serial device.
The default is "DTR/DSR."
Enter the printer IP address.
APD Installation and Setup 2-9