Connecting The Cables (Desktop Stand Type) - Eizo FlexScan L360 User Manual

Connecting the Cables (Desktop Stand Type)

(1)Be sure that the power switches of both the PC and the LCD monitor
are OFF.
(2)Remove the D-Sub connector holder.
a) Hand-loosen the screws at the center of the holder.
b) Pull the holder away while squeezing both sides of the holder.
(3)Plug the signal cable (which is marked "LCD") into the D-Sub
connector (Signal 1) at the rear of the monitor. Please ensure that the
arrow mark on the casing of the connector is visible when connecting.
See note.
When connecting the signal cable, check that the shape of the cable
connector matches the shape on the LCD monitor.
(4)Replace the D-Sub connector holder and hand-tighten the screw.
(5)Plug the other end of the cable into the video connector on the rear of
the PC.
D-Sub connector
holder
1 INSTALLATION
E
17