4.20 Modem jack / Wireless communication SW
4. Push the wireless communication SW from the inside of the base assembly to
remove.
Figure 4-30 Removing the wireless communication SW
Installing the Modem jack / Wireless communication SW
To install the Modem jack / Wireless communication SW, follow the steps below and refer to
Figure 4-29 and 4-30.
1. Insert the wireless communication SW into the hole of the base assembly from the
outside.
2. Install the Modem jack into the slot of the base assembly and pass the Modem jack
cable into the slot and close the insulator.
PORTÉGÉ M500 Maintenance Manual (960-559)
4 Replacement Procedures
Wireless communication SW
[CONFIDENTIAL]
4-51