Download  Print this page

Table Of Contents - NEC NP-M311W Installation And Assembly Manual

Custom ceiling mount for nec m260x, m260w, m271x, m300x, m300w m300xs, m300ws, m311x, m311w, p350x, p350w, p420x projectors
Hide thumbs

Advertisement

NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum UL Load Capacity. See page 1.
• If mounting to wood joist ceilings, make sure that mounting screws are anchored into the center of the joist. Use of
an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with
the hardware included in this product as specified in the installation sheet. To mount this product to an alternative
supporting surface, contact Peerless customer care at 1-800-865-2112.
• This product was designed to be installed on the following ceiling construction only;
CEILING CONSTRUCTION
x
Wood Stud
x Wood Joist
x Solid Concrete
Cinder Block
Brick
Other or unsure?
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 5/16" bit for concrete surface
• 5/32" bit for wood studs
• level

Table of Contents

Parts List.................................................................................................................................................................................3
Installation to Extension Columns / Ceiling Plate ...................................................................................................................4
Installation to Wood Joist Ceilings . .........................................................................................................................................5
Installation to Concrete Ceilings .............................................................................................................................................6
Installation to Threaded Rods . ................................................................................................................................................7
Attaching Adapter Plate to Projector.......................................................................................................................................8
Attaching Adapter Plate to Projector Mount............................................................................................................................9
Projector Alignment ..............................................................................................................................................................10
Visit the Peerless Web Site at www.peerlessmounts.com
ADDITIONAL HARDWARE REQUIRED
None
None
None
Contact Customer Service
Contact Customer Service
Contact Customer Service
WARNING
2 of 10
For customer care call 1-800-865-2112

Advertisement

loading

  Related Manuals for NEC NP-M311W