Download  Print this page

Projector Alignment; Issued: 10-01-10 Sheet #: 056-9034-4 - NEC NP-M311W Installation And Assembly Manual

Custom ceiling mount for nec m260x, m260w, m271x, m300x, m300w m300xs, m300ws, m311x, m311w, p350x, p350w, p420x projectors
Hide thumbs

Advertisement

Projector Alignment
To adjust yaw (swivel) for wood stud, concrete ceiling, and threaded rod mounting applications: Loosen
9
wood screws (F) if flush mounted to wood joists (page 5) or concrete ceilings (page 6), or loosen locknuts on
threaded rods (page 7), until projector mount can be rotated. Rotate mount to desired position and retighten
screws or locknuts.
To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and
turn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand for
easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
SCREW FOR YAW (SWIVEL) STOP
(REFER TO STEP 1, INSTALLATION
TO EXTENSION COLUMNS, FIG. 1.2)
To prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screws
9-1
on the projector mount assembly using 4 mm security allen wrench (B) to lock the pitch and roll adjustments as
shown below. Note: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.
• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly
or damage may occur.
TO LOCK PITCH, TIGHTEN
TAMPER RESISTANT
SECURITY SCREW
Visit the Peerless Web Site at www.peerlessmounts.com
ARROW INDICATES
FRONT OF MOUNT
CAUTION
A
SIDE VIEW
10 of 10
All other brand and product names are trademarks or registered trademarks of their respective owners.
KNOB FOR PITCH
ADJUSTMENT
BACK OF MOUNT
KNOB FOR ROLL
ADJUSTMENT

ISSUED: 10-01-10 SHEET #: 056-9034-4 07-29-11

For customer care call 1-800-865-2112
© 2011, Peerless Industries, Inc. All rights reserved.

Advertisement

loading

  Related Manuals for NEC NP-M311W