Hitachi CP-X2 - XGA LCD Projector User Manual page 53

4.1 Utilize "MIU Live Viewer" – Advanced - (Continued)
[Connection]
1) Connect all PCs and projector using LAN cables and hub as shown in Fig.
4.1.1.a.
2) Start up "MIU Live Viewer" in each PC. Check the IP address in PCs and
confirm xxx of [192.168.1.xxx] in IP address is set different value in each PC.
3) Click [Find] button in "MIU Live Viewer" and search projector.
4) When projector is found, click [Option] button in "MIU Live Viewer". Then open
"General" tab and select the number of PCs to connect as "MultiPC Mode".
After selecting, click [Close] button.
5) Click Capture Start button.
6) Repeat from 3) to 5) to all PCs.
* Display screen priority
In case of multiple PCs connection, priority is decided automatically comparing
when each PC is connected. In each mode, priority is as shown in Fig. 4.1.1.b.
(Smaller number is prioritized.)
Detailed conditions and specifications for priority are as follows.
a) The PC that connects later has the highest priority.
b) When "MultiPC Mode" (2 to 4 PCs) is changed to 1 PC, changed 1 PC has the
highest priority.
c) "MultiPC Mode" can be changed settings freely even the PC is communicating.
d) When the number of selected PC is smaller than the number of connected PC,
lower priority PC screens are not displayed, but connections with projector are
kept. When more than 5 PCs are connected with projector, lower priority PC
connection is disconnected.
NOTE
• If Multi PC is selected and the screen resolution which one of
connected PCs has is changed, the PC will be given the highest priority and the
mode (1 to 4PCs) set on the PC will be effective on the projector.
• On "MultiPC Mode" (2 to 4 PCs), the image resolution of each screen is 1/4 of
the original, so small letters or lines might be illegible. It is recommended to use
letters as large as possible.
Fig. 4.1.1.b Priority in each mode
4. Utilize projector – Advanced -
53