Table of Contents
Advertisement
Setup
Assembly Guide
Fully assembled drum kit
(DTX450K shown)
Step 5
Step 10
Step 8
Step 4
Step 7
Step 1
Preparing the base
supports
!7
q
Front
1.
Take the two base supports (q) and the tuning key (!7 )
from the package, and using the tuning key, securely
tighten the s key bolts (i.e., the key bolts labeled s in
the figure).
NOTE
The two base supports are identical.
2.
Using the tuning key, loosen the
the two base supports (q).
3.
Viewing from the front as shown in the figure, place the
base supports (q) at the left and right approximately 50
cm apart.
Step 6
50 cm
q
key bolt on each of
• Choose a flat, hard surface on
Step 11
which to assemble your elec-
tronic drum kit.
• Take care to avoid mixing up
parts or assembling them in the
wrong direction. In addition, the
assembly steps should be com-
Step 9
pleted one at a time in the order
described.
• The assistance of at least one
other person will be required
when assembling the electronic
drum kit.
Step 3
• Once a piece has been assem-
bled, be sure to tighten the cor-
responding nuts or bolts.
• To disassemble your electronic
drum kit, carry out the assembly
Step 2
sequence in reverse.
Step 1
Step 2
Attaching the verti-
cal supports
w
Joint
Left
1.
Take a vertical support (w) from the package, and
insert it fully into the joint on the left base support.
NOTE
The two vertical supports are identical.
2.
Using the tuning key, tighten the
Step 1
loosened in
in order to secure the vertical sup-
port (w) in place.
CAUTION
After completing this step, lay the assembly down
safely to prevent it from falling over.
3.
1.
2.
Repeat
and
to assemble the right upright bar.
DTX400K/DTX430K/DTX450K
CAUTION
Right
key bolt that you
Owner's Manual
11
Hide quick links:
Advertisement
Table of Contents
