Difficulty Level; Ignore Timing; Groove Tracker Return Time - Yamaha DTX400K Owner's Manual

Setting Parameters using Menu Mode

6-2. Difficulty Level

Steps:
MENU ([KIT] + [SONG])  [6]  [2]  Setting
Using the following procedure, you can set the level of
training difficulty for Tempo Up/Down (page 33), Change
Up (page 34), and Pad Gate (page 37).
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [6] to select the Training Settings
parameter group.
3.
Press number button [2] to select the Difficulty Level
parameter.
4.
Select a new difficulty level using the corresponding
number button ([1] to [5]). The higher the level, the
more difficult the training.
NOTE
The level of difficulty set using this parameter applies only to the
Tempo Up/Down, Change Up, and Pad Gate training types. Other
types of training are not affected.

6-3. Ignore Timing

Steps:
MENU ([KIT] + [SONG])  [6]  [3]  Setting
Using the following procedure, you can set the Ignore Tim-
ing parameter for Tempo Up/Down (page 33), Change Up
(page 34), and Pad Gate (page 37) training. When set to
"On", the pads will produce a sound whenever they are
struck; when "Off", only pads played exactly in time will
produce a sound.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [6] to select the Training Settings
parameter group.
3.
Press number button [3] to select the Ignore Timing
parameter.
50
DTX400K/DTX430K/DTX450K
Setting
Setting
1 to 5
Setting
Owner's Manual
4.
Set the parameter using number button [1] or [2]. The
available settings are as follows.
Number
Setting
button
Pads played out of time will not
[1] Off
produce a sound.
Pads will produce a sound when-
[2] On
ever they are played.
NOTE
This parameter applies only to the Tempo Up/Down, Change Up,
and Pad Gate training types. Other types of training are not
affected.

6-4. Groove Tracker Return Time

Steps:
MENU ([KIT] + [SONG])  [6]  [4]  Setting
Using the following procedure, you can set the period of
time after which the practice drum pattern in Groove
Tracker training (page 36) will return to the start when you
stop drumming.
1.
While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2.
Press number button [6] to select the Training Settings
parameter group.
3.
Press number button [4] to select the Groove Tracker
Return Time parameter.
4.
Enter a new return time setting using number buttons
[1] to [10/0]. The bigger the setting, the longer the
return time.
Setting
1 to 10
NOTE
• When set to [1], the practice drum pattern will not return to the
start.
• The time set using this parameter only applies to Groove Tracker
training. Other types of training are not affected.
Description
Setting