Table of Contents
Advertisement
Assembly Guide
Step 10
Attaching the hi-hat
Adjusting the position of the hi-
hat stopper pin
30°
Pin
Front
Stopper
Hi-hat holder
Front
This figure shows the hi-hat holder correctly inserted in
the DTX450K. It is inserted from the front in the DTX400K
and DTX430K, and therefore, faces in the opposite direc-
tion.
1.
Using the tuning key, loosen the
stopper, which is located at the top of the hi-hat holder.
2.
Adjust the position of the pin until, as shown in the fig-
ure, it is approximately 30° counter-clockwise from the
front-rear direction of the kit when viewed from above.
3.
Tighten the
key bolt to secure the stopper pin.
Assembling the hi-hat pad
Washer
Stopper
All three of the cymbal/hi-hat pads (!2 ) are identical. One
of these is to be used as the hi-hat pad.
1.
Remove the wing nut, the washer, and the upper felt pad
from the hi-hat holder. (Do not remove the lower felt
pad.)
2.
Take the hi-hat pad (!2 ; one of three) from the package
and place it on the hi-hat holder with the stopper pin
also passing through the hole provided.
3.
Replace the felt pad removed in
(!2 ) .
4.
Replace the washer removed in
5.
Tighten the wing nut to secure the hi-hat pad (!2 ) in
place. Ensure that the wing nut is firmly tightened.
16
DTX400K/DTX430K/DTX450K
Pin
30°
key bolt on the
Wing nut
Felt pad
!2
Felt pad
Hi-hat holder
1.
above the hi-hat pad
1.
above the felt pad.
Owner's Manual
Step 11
Assembling the cym-
bal pads
In this step, the two remaining cymbal/hi-hat pads (!2 ) are
1.
assembled. Accordingly,
to
NOTE
The two cymbal pads (!2 ) are identical.
1.
Remove the wing nut and the upper felt pad from the
cymbal holder. (Do not remove the lower felt pad.)
2.
Place the cymbal pad (!2 ) on the cymbal holder, with
the holder passing through the central hole.
3.
Replace the felt pad removed in
pad (!2 ) .
4.
Tighten the wing nut to secure the cymbal pad (!2 ) in
place.
Step 12
Rotating the tom
pads into place
y
Step 12
applies to each of the three tom pads. Accord-
1.
3.
ingly,
to
must be performed three times.
1.
key bolt on the tom pad (e or y).
Loosen the
2.
Rotate the tom pad to a position where it will be easy to
play. (If necessary, refer to the picture of the properly
assembled kit on page 11.)
3.
Tighten the
key bolt to secure the tom pad in place.
Wing nut
Felt pad
!2
Felt pad
Cymbal holder
4.
must be performed twice.
1.
above the cymbal
e
Hide quick links:
Advertisement
Table of Contents
