HP A1210n - Pavilion - 512 MB RAM Getting Started Manual page 36

30
Getting Started Guide
4 For type 6 connectors only, connect the side speaker cable to the gray
connector on the back of your PC.
5 Connect the center speaker and subwoofer speaker cable to the gold connector
on the back of your PC.
6 Connect the cables to the audio system.
7 Connect the front, rear, side, and center speakers to the subwoofer. Refer to the
speaker documentation.
8 Turn on the PC.
NOTE: Always turn on the PC before you turn on the speaker system.
9 Plug in the speaker system power.
10 Turn on the speaker system.
11 After the speakers are connected to the PC, configure the audio software for
sound output for your PC model:
• Type 6 connectors: See "Configuring Audio Output with Sound Effect
Manager" on page 38.
• Type 6 connectors — multi-streaming: See "Configuring Audio Output with
Realtek HD Sound Effect Manager" on page 41.
The following diagram shows a typical 7.1 audio installation: