Changing The Remote Controller Mode - Integra NAC-2.3 Instruction Manual

Index parts and facilities
A Display button
Press to change the display mode.
B Cursor / / /
Press to locate your selection.
C Select button
Determines your selection or saves a new
setting.
D Setup button
Press to set up the NAC-2.3.
E Operation buttons
, (FR/FF) buttons
Press to fast-rewind or fast-forward the
current track.
(Pause) button
Press to pause the playback.
(Play) button
Press to start playback.
(Stop) button
Press to stop the playback.
, B/F-Skip buttons
Press to move to the previous or next track.
F Random button
Press to play the selected track list at random.
G Repeat button
Press to repeat the selected single track or
track list.
H Volume / buttons
Press to adjust the volume.
buttons
Changing the remote controller
mode
When you use any Integra/Onkyo products other
than the NAC-2.3 in the same room, the
operations made with the NAC-2.3's remote
controller may also cause the other Integra/Onkyo
products to operate. To avoid this, you can change
the remote controller mode both for the NAC-2.3
and its remote controller choosing from three
modes (1, 2 or 3).
To change the remote controller mode for the
remote controller, hold the Standby button on the
remote controller and press the Select button, then
release these buttons simultaneously. Within 5
seconds after releasing the buttons, enter the
appropriate mode (1, 2 or 3) using the numeric
keys. The default mode is 1 for both the remote
controller and NAC-2.3.
After changing the remote controller mode, make
sure that the remote control "Remote ID code" on
the NAC-2.3 is set to the same mode as the remote
controller. (see Page 57)
17