Integra NAC-2.3 Instruction Manual page 55

Configuring Various Settings
• Specify Port number
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
"Proxy Setup" setup menu, select "Port No"
using the Cursor / button. Then press the
Select button.
Enter the port number using the Cursor
/ button, and then press the Select button to
confirm the new setting.
• Specifying Proxy Address
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
"Proxy Setup" setup menu, select "Proxy
Address" using the Cursor / button. Then
press the Select button.
Select the character to enter using the Cursor
/ / / button, then press the Select button
to enter the selected character.
After completing entering the Proxy Address,
press the Setup button.
Client Settings:
From the "System" → "Ethernet Settings" →
setup menu, select "Client" using the Cursor
/ button. Then press the Select button.
• Specifying the client name (a name
used to identify your NAC-2.3 on the
network)
/ /
You can specify the name for the NAC-2.3 as
the client name.
From the "System" → "Ethernet Settings" →
"Client" setup menu, select "ClientName"
using the Cursor / button. Then press the
Select button.
Press the Display button to select the
character type to enter. Each time you press
the Display button, the character type cycles.
Press the Cursor
select your desired character. Press the Select
button to enter the selected character.
After entering the client name, press the Setup
button to confirm the new setting.
Note:
If you connect two or more NAC-2.3 to the
same LAN, use the separate client name for
each of the NAC-2.3s.
/ button repeatedly to
55