Integra NAC-2.3 Instruction Manual page 53

Configuring Various Settings
• Specifying the IP address:
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
"IP Address" setup menu, select "IP Address"
using the Cursor / button. Then press the
Select button.
Enter the IP address using the Cursor
button to select the digit to change and the
Cursor / button to change the number.
Press the to increment and
the number. Then press the Select button to
confirm the new setting.
Specify the IP address within the following
range:
CLASS A: 10.0.0.0 to 10.255.255.255
CLASS B: 172.16.0.0 to 172.31.255.255
CLASS C: 192.168.0.0 to 192.168.255.255
Because the most of the routers commercially
available is set to the CLASS C IP address,
specify the CLASS C IP address for the NAC-
2.3. If you set the IP address out of the ranges
shown above, you cannot use the Net-Tune
function.
• Specifying the IP mask:
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
"IP Address" setup menu, select "IP Mask"
using the Cursor / button. Then press the
Select button.
Enter the IP mask using the Cursor
button to select the digit to change and the
Cursor / button to change the number.
Press the
the number. Then press the Select button to
confirm the new setting.
• Specifying the gateway address:
/
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
to decrement
"IP Address" setup menu, select "Gateway"
using the Cursor / button. Then press the
Select button.
Enter the gateway address using the Cursor
the Cursor / button to change the number.
Press the
the number. Then press the Select button to
confirm the new setting.
• Specifying the DNS address:
(This setting is required only when you
turn off the DHCP function.)
From the "System" → "Ethernet Settings" →
"IP Address" setup menu, select "IP DNS1"
using the Cursor / button. Then press the
Select button.
to increment and
/ button to select the digit to change and
to increment and
/
to decrement
to decrement
53