Clearing Jams Under The Fuser Or Fuser Cover - IBM InfoPrint 1634 User Manual

3
If the paper will not move, remove all four photoconductors (for more information, see "Removing the color supplies"
on page 51). Clear the jam, and then replace the photoconductors.
4
Close the lower door, and then close the upper door.

Clearing jams under the fuser or fuser cover

Jams under the fuser or fuser cover
When paper is jammed under the fuser or the fuser cover, 201.xx Paper Jam appears.
CAUTION: The fuser and the inside of the printer near the fuser may be hot. Wait for the fuser to cool before clearing
jams from this area.
Warning: To avoid overexposing the photoconductors, do not leave the inner door open longer than 10 minutes.
1
Open the upper and inner doors. The lower door opens with the inner door.
2
Determine where the jam is located:
a
If paper is visible under the fuser, grasp it on each side and pull it forward.
b
Otherwise, grasp the fuser cover by the tabs and lift it. Pull the jammed paper up and out. Close the fuser cover.
3
Close the lower door, and then close the upper door.
2
1 2
63
1