Table of Contents
Advertisement
1
Use the marks above the slot to adjust the width guide for standard paper sizes. For odd sizes, once the paper is
loaded, move the width guide until it lightly touches the sheet.
Warning: Do not force the width guide against the paper, or it could be damaged.
2
Load one sheet of paper flush with the right side of the slot.
Load an envelope with the flap side up. The orientation of the envelope in this case is the same as its orientation when
it is loaded into the multipurpose feeder. For an illustration of proper envelope orientation, see "Load envelopes with
the flap side up." on page 32.
3
Push the paper in until it stops. The printer pulls it in farther.
Using the manual feeder
Use the manual feeder to load single sheets not kept in a tray, such as letterhead.
From Print Properties, set the Paper Size and Paper Type. When Load manual feeder with <x> appears on the
display, load a single sheet into the manual feeder, and then press
Follow these guidelines when using the manual feeder:
•
Load only one sheet at a time.
•
Load paper with the top edge going into the manual feeder first.
•
Load preprinted letterhead facedown.
•
To achieve the best possible print quality, use only high-quality paper designed for laser printers.
•
To prevent jams, do not add paper to the manual feeder while a job is printing.
For information about supported paper sizes and types, see the section about paper and specialty media.
Using the standard exit bin
The standard exit bin holds up to 250 sheets of 20 lb paper. It collects print jobs facedown.
.
33
Advertisement
Table of Contents
