Controlling The Projector By A Computer; Connecting The Power Cord - Eiki EIP-250 Owner's Manual

Eiki international dlp projector owner's manual

Table of Contents

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-

232C adaptor and an RS-232C serial control cable (cross type, commercially available), the com-

puter can be used to control the projector and check the status of the projector. See page

details.

When connecting to a computer using an RS-232C serial control cable and a DIN-

D-sub RS-232C adaptor

Note

• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the

owner's manual of the computer for details.

• See page

for connection of an RS-232C serial control cable.

Info

• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This

may damage your computer or projector.

• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.

This may damage your computer.

Plug the supplied power cord into the

AC socket on the rear of the projector.

Then plug into AC outlet.

To RS-232C terminal

DIN-D-sub RS-232C

adaptor (supplied)

RS-232C serial control cable (cross type, commercially available)

To RS-232C terminal

AC socket

To AC outlet

for

Computer

Power cord

(supplied)

Table of Contents

Eip-2600