Connecting The Scanner To The Computer Network; Changing The Network Default Settings - Kyocera KM-6230 Instruction Handbook Manual

(2) Connecting the Scanner to the Computer Network

1 Turn the main switch, located on the left side of the scanner,
OFF (O).
CAUTION: ALWAYS turn the main switch OFF when
connecting the Ethernet cable.
2
Connect a 10BASE-T or 100BASE-TX cable to the Ethernet
cable connector B located on the left rear side of the
scanner.
3
Turn the main switch to the copier back ON ( | ).
Section 3 Using the Scanner

(3) Changing the Network Default Settings

Perform the following procedure when you want to set the scanner
address, make other DHCP-related settings or change the manage-
ment pin code that gives you access to the setting screen which
allows you to change these network default settings.
Press the Copier/Printer/Scanner key to display the basic
1
scanning screen.
2 Touch the "Default" key.
The management pin code input screen will appear.
3
Use the numeric keys to enter the management pin code
"6200".
* If the pin code that you entered matches the registered
one, the screen will change to the network default setting
screen.
* You can change the 4-number management pin code as
desired. (See " Changing the Management Pin Code for
the Scanner" on page 3-3.)
NOTE: The management pin code for the scanner is
different than the pin code you must use when this
machine is used as a copier or a printer.
3-2