Network Settings - Kyocera KM-6230 Instruction Handbook Manual

Section 2 Using the Printer
6 Emulation
Used to select the printer language. To switch to another emulation
mode, press the Change key.
* Emulation (Network) is displayed only if the network board is
installed.
1
Open the screen for emulation setting.
Press the "–" key or "+" key to display a list of the available
emulation modes, then select the desired one.
* By default, "PCL 6" is selected.
(The Print KPDL Errors option is displayed only when
KPDL or KPDL (AUTO) is selected.)
"ON" or "OFF" can be selected by using the "–" key or "+"
key.
2
If KPDL (AUTO) is selected at step 1, the Alternate
Emulation option will appear. This allows you to select an
alternate emulation mode in cases when no print can be
made in KPDL mode.
After changing the printer setting, press [End] button the recover the
printer to online status, then turn OFF/ON the main switch.
It is only after turning the main switch OFF/ON, the printer setting will
be reflected.
2-11

(3) Network settings

It is possible to set the Internet Protocol (IP) address, Subnet Mask
and Gateway address.
* These settings should be performed by the network manager or
under that person's instruction.
After changing the printer setting, press [End] button the recover the
printer to online status, then turn OFF/ON the main switch.
It is only after turning the main switch OFF/ON, the printer setting will
be reflected.
1
Make sure that "Off line" is shown in the message display
(the printer is currently offline) and press the "Default" key.
The printer setting screen will appear.
2 Press the "Network setting" key.
The Pin code screen will appear.